How to Determine Correct SnapPad For Winnebago Vista  

The SnapPad Prime Jack Pads #SP84FR4 are specifically designed to fit the Power Gear Leveling Systems w/ 10" Round Concave Jack Feet on your 2014 Fleetwood Bounder 34B. The Pads #SC99MR Stromberg told you to use will not fit on your Bounder…

While I was able to find your 2021 Newmar Ventana 3412 comes with a Equalizer leveling system, I was unable to verify exactly what legs it will come with. There are a few choices so be sure to check your Equalizer leveling system. 10" Round Jack…

Hey Patrick, so for your leaf spring upgrade I am going to need to know a couple of things before I can get you over to the right part. Specifically, the length from eye to eye, the spring width, leaf thickness, and the number of leaves. From here I…

You are correct that the original part has been discontinued. The replacement seat #DOM25FR (385343831) is going to be your best bet. It looks like your current seat is about 14" or 14-1/2" across and about 16" long. The replacement…

If you have the Gooseneck versions of the Curt CrossWing ( #C92DR or #C32DR) you unfortunately would not be able to use the Rota-Flex with it. The pivoting head causing too much strain for the single point of contact you have with a gooseneck hitch.…

Thank you for the pictures- they're always helpful! I have a solution for you, but the Lippert gear box you were looking at is a replacement for the newer Kwikee 32 Series Steps. I spoke with my contact at Lippert and they said that the gearbox…

The correct SnapPad kit for your Replacement Foot Plate #LC359344 is the SnapPad Prime Jack Pads #SP84FR4. If you need just a single SnapPad then you're looking for part #SP84FR instead.

We have exactly what you're needing, Rex! For your 9.9" diameter HWH jack feet you need the SnapPad HiWay 10 Jack Pads for HWH and Atwood Leveling Systems w/ 10" Round Jack Feet #SN58FR.

I reached out to my contact at Dexter Axle who said that your axle is rated for 3,500 lbs and it uses inner bearing #L68149, outer bearing #L44649, and the grease seal #58846. All of these can be found in the kit #BK2-100 if you are needing to…

That's a good question and the difference between the two SnapPad Jack Stand Pads for Motorhome are different shapes and depths, it isn't solely the notch in the center. I added photos of the two pads side-by-side so you can see the…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

Hey Brad, thanks a bunch for going ahead and getting all those measurements in advance. Based on the measurements you've given, the TorkLift GlowStep Revolution Uprising Steps w/ Booster Step #TL52SR will work perfect for your coach. These steps…