Bolt Pattern for Dexter Axle 12" Electric Brake Assembly Kit  

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

I'll need to know the inner and outer wheel bearing reference numbers and wheel bolt pattern. With that information, I can recommend replacement bearings, seals, brake assemblies and hub/drums. You'll also want to carefully examine…

The Dexter Electric Trailer Brake Kit #23-105-106 are a replacement set for the 023-358-00. This kit includes a right and left brake assembly that is manually adjustable. I recommend the Dexter Nev-R-Adjust Electric Trailer Brake Kit #23-458-459 as…

Hello Brian, we do offer some parts that will work for your application and will be very similar to the BPH1206EPR kit that you mentioned. Like you said, the 12 x 2-1/2 drums are pretty uncommon, so I would have to recommend going instead with the…

Your dimensions are a little unique but I would assume you have an AL KO brand axle with a 6k axle and the correct assemblies would be the part #23-105-09 and #23-106-09. This is 12 inch in diameter assembly that can attach with a 4 or 5 lug bolt…

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

We've got you covered! To replace your wheel bolts you need the Dexter Wheel Bolt #7-262 which is a 1/2" diameter and 2-11/16" long. Since your hub and drum assembly looks to be pretty worn though I recommend just replacing the whole…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

When it comes to installing new brakes onto your Dexter 8-133 axle you will have to cut off the welded flange/brake unless the flange has a bolt pattern of 5 on 3-7/8 inches. The Brake Mounting Flange #4-44-1 will get welded to the spindle at the end…

Yes it sure will. The Dexter #23-458-459 consists of both the right and the left 6K 12 inch self-adjusting brake assemblies. Part #23-458-00 (or #23-458 which is the number we use) would only include the left hand brake assembly. If you click the…

Standard tapered trailer wheel bearings are recommended to be re-packed with fresh bearing grease about every year or every 12,000 miles under normal use. In certain conditions this interval could be shorter, such as if you routinely tow the trailer…